Copper-base active metal interlayers were used to bond in situ reinforced silicon nitride (Honeywell AS800) at 1317 K for 5 and 30 min in vacuum. The joints were characterized using scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), electron back scattered diffraction (EBSD), and transmission electron microscopy (TEM). A Ti-rich interaction zone (∼3.0–3.5 μm thick)…
The microstructural and high-temperature mechanical characteristics of directionally solidified rods of Al2O3–Er3Al5O12–ZrO2 ternary eutectic oxides processed by the laser-heated floating zone method at different growth rates have been investigated. The eutectic microstructure displayed an entangled three-dimensional network of Al2O3 and Er3Al5O12 phases of similar sizes, elongated along the growth direction; the minority zirconia phase formed…
NiO/3YTZP (3 mol% Y2O3-stabilized tetragonal ZrO2) composites with 40 mol% NiO (26 vol% NiO) have been fabricated by mechanical mixing of NiO and 3YTZP powders and sintering at 1500 °C for 10 h in air. The resulting microstructures have been characterized by electron microscopy. Compressive mechanical tests at constant strain rate were conducted on these…
Ti1−xAlxN thin films with different Al content were deposited by magnetron sputtering. The combination of electron energy loss spectroscopy (EELS) and energy dispersive spectroscopy (EDS) was used to evaluate the composition of the coatings. The effect of Al content on the morphology and properties of the coatings was investigated. High resolution electron microscopy and related…
The machinability of materials is a dynamic field with enormous implications in different industrial sectors because manufacturers are constantly looking for improvements that can increase the overall productivity. Manufacturers of cutting tool inserts need to develop products that can perform at higher speeds and last longer under increasingly rigorous operating conditions. It has been revealed…
Nanocrystalline Mg powders of different particle size were obtained by inert gas evaporation and studied during electrochemical and gas-phase hydrogen cycling processes. The samples were compared to dehydrided samples obtained by mechanical milling of MgH2 with and without 2 mol% Nb2O5 as catalyst. The hydrogen overpotential of the pure Mg, which is a measure of…