Determination of the local structure of a highly dispersed Pd-Nanosystem located on a titanium dioxide carrier

This work is devoted to a structural study of a highly dispersed Pd nanosystem, which is stabilized in the TiO2 matrix, by XAFS spectroscopy. Nanocomposite was prepared from bimetallic PdCo(mu-OOCMe)(4)(NCMe) precursor followed by processing in several ways: calcination in air and in argon and microwave irradiation. The local structure of Pd catalysts formed by different…

N- and/or W-(co)doped TiO2-anatase catalysts: Effect of the calcination treatment on photoactivity

A series of nanosized W,N-codoped and single-doped N- and W-anatase-TiO2 catalysts have been prepared by a microemulsion method and calcined at different temperatures. The activity in the sunlight selective photo-oxidation of toluene and styrene has been correlated with structural, electronic, and surface examinations of the catalysts done with the help of XRD-Rietveld, N-2 physisorption, X-ray…

Doping level effect on sunlight-driven W,N-co-doped TiO2-anatase photo-catalysts for aromatic hydrocarbon partial oxidation

A series of nanosized W,N-co-doped anatase TiO2 catalysts with different dopant contents has been prepared by a microemulsion method and examined in the sunlight selective photo-oxidation of toluene and styrene. The activity results have been correlated with structural, electronic, and surface examinations of the catalysts done with the help of XRD-Rietveld, N-2 physisorption and NH3…

The Multistep Nature of the Kaolinite Dehydroxylation: Kinetics and Mechanism

The thermal dehydroxylation of kaolinite has been reexamined using small sample weights, a homogeneous particle size distribution and high-vacuum conditions in order to reduce the influences of heat and mass-transfer phenomena. The controlled rate thermal analysis (CRTA) technique, which was specially developed to minimize the pressure and temperature gradients through the sample, was employed to…

Influence of sulfur on the structural, surface properties and photocatalytic activity of sulfated TiO2

TiO2 materials were prepared by sol–gel method and then impregnated with sulfuric acid and calcined using different temperatures and atmosphere (air and nitrogen). Systematic variation of these two experimental parameters makes possible to modulate the amount of surface sulfur from the impregnation procedure. The best photocatalyst for liquid phenol degradation was obtained after calcination at…