In this study, a comparative analysis is made of TiO2 modified with Pt or Au in NO photoxidation under different radiation and humidity conditions. The metals were deposited on the TiO2 surface using two methods, photodeposition and chemical reduction. All catalysts were supported on borosilicate 3.3 plates using a dip-coating technique. These modified photocatalysts were…
ZnO nanoparticles have been successfully synthesized by a facile precipitation procedure by mixing aqueous solutions of Zn(II) acetate and dissolved Na2CO3 at pH ca. 7.0 without template addition. We have investigated the effect of annealing temperature in the final surface and structural properties. Photocatalytic studies were performed using two selected substrates, Methyl Orange and Phenol, both…
Mixed oxides, alpha-Fe2O3/Bi2WO6, were prepared using a mechanical mixing procedure by adding to the Bi2WO6 previously obtained by hydrothermal method the corresponding amount of a prepared alpha-Fe2O3, the latter obtained by thermal decomposition of Fe(NO3)center dot 9H(2)O. The physicochemical surface, structural, morphological characteristics and optical properties of the samples, single and mixed, were determined by…
In this study, a series of photocatalysts based on TiO2 was tested in the elimination of Escherichia coli (E. coli) from urban wastewater. Firstly, TiO2 obtained by sol-gel method was modified by sulfation, and then gold or platinum nanoparticles were photodeposited on sulfated titania surface. Platinized samples were also prepared with different Pt content of…
In this work, a new photocatalyst based on bismuth titanates with outstanding visible photocatalytic activity was prepared by a facile hydrothermal method. The synthesised material showed visible activity as high as UV activity of commercial TiO2 P25 under the same experimental conditions for phenol degradation. A wide characterisation of the photocatalyst was performed. The material…
In this work it was studied the efficiency of a photocatalytic process for the removal of patent blue V. This dye is very difficult to remove by conventional treatments such as adsorption or coagulation therefore the photocatalytic process is a very interesting alternative for the removal this dye mainly because it does not require expensive…
The present work reports the renewable hydrogen production by photocatalytic degradation of glucose over commercial and home prepared TiO2 modified by the simultaneous presence of fluorine and Pt (Pt-F-TiO2). The obtained materials were widely characterized by different techniques (XRD, SBF, UV-Vis DRS, XRF, SEM and TEM) and it was found that surface area, anatase/rutile ratio…
A comparison is made in this study of the effectiveness of various commercial catalysts in the oxidation of NOx by heterogeneous photocatalysis. The following catalysts were considered: Aeroxide TiO2 P25, Aeroxide TiO2 P90, Hombikat UV-100, Kronos vlp7000, CristalACTIV PC105, CristalACTIV PC500, Kemira 650 and Anatasa Aldrich. All catalysts were deposited by a dip -coating technique…
La fotocatálisis heterogénea es un proceso avanzado de oxidación que ha sido objeto de una enorme cantidad de estudios relacionados con la purificación de gases y del agua. La mayoría de estos estudios se han realizado para el tratamiento de aguas y utilizando el TiO2 o materiales basados en este óxido y más recientemente, aunque en…
In this work, titanium dioxide has been modified by sulfation, fluorination and simultaneous Pt nanoparticles deposition; the influence of these treatments on the photocatalytic activity of this oxide has been studied. A complete characterization study was carried out and it was observed that sulfation, fluorination and metallization were important factors influencing the TiO2 properties. The photocatalytic…