This paper is devoted to the development of Ti(C,N)-based nanocomposite protective coatings consisting of nanocrystals of a hard phase (TiN or TiCxNy) embedded in an amorphous carbon-based matrix (a-C or a-CNx). The objective here is the achievement of a good compromise between the mechanical and tribological properties by the appropriate control of the hard/soft phase…
Fretting corrosion damages are commonly observed when two metallic bodies, which are in contact with each other, are subjected to oscillatory motions of low amplitude. Such kind of degradation mode is often responsible for limited durability of aeronautical joints. In the present paper, a multifunctional duplex coating based on Si–C–N and diamond-like carbon (DLC) materials,…
WC/amorphous carbon (a-C) thin films were deposited by dual magnetron sputtering from individual WC and graphite targets. The influence of film composition and microstructure on the optical and electrical properties was investigated. As evidenced by x-ray photoelectron spectroscopy and grazing angle x-ray diffraction measurements, the WC/a-C films are composite materials made of hexagonal W2C and/or…
The performance of protective thin films is clearly influenced by their microstructure. The objective of this work is to study the influence of the structure of TiC/a-C nanocomposite coatings with a-C contents ranging from ~ 0% to 100% on their mechanical and tribological properties measured by ultramicroindentation and pin-on-disks tests at ambient air, respectively. The…
Titanium carbide (TiC) and nitride (TiN) are two of the most used materials in the field of protective coatings, due to their optimal mechanical and tribological properties. The addition of the second phase can provide extra benefits to the coating, like improved hardness, reduced friction and/or oxidation resistance. In this work, we present two series…
Gold nanoparticles with an average particle size below 3 nm have been synthesized and stabilized with different thiol-derivatized molecules for studying the influence of the capping molecule on the magnetic behavior. Thiolated-alkane chains with different lengths as well as a thiol-containing biomolecule (tiopronin) have been selected as protecting shells for the synthesized NPs. Magnetic characterization…
Carbon nanotubes (CNTs) have been grown both on a sample of stainless steel (317-2R) and on the same steel coated with cobalt colloid nanoparticles. Both materials are suitable supports for the growth of vertically aligned carbon nanotubes, although a more sparse growth of significantly thicker carbon nanotubes is observed in the case of the bare…
El proyecto se dedica al desarrollo, mejora, y standarización de las técnicas de caracterización, los métodos y los equipos en los ensayos nano-mecánicos. Las actividades a nivel Europeo, coordinadas por un centro virtual, mejorarán la metrología de nanoindentación actual y permitirán un conocimiento más profundo de la relación estructura-propiedades en la nano-escala. Estos métodos son…
Nanocrystalline Mg powders of different particle size were obtained by inert gas evaporation and studied during electrochemical and gas-phase hydrogen cycling processes. The samples were compared to dehydrided samples obtained by mechanical milling of MgH2 with and without 2 mol% Nb2O5 as catalyst. The hydrogen overpotential of the pure Mg, which is a measure of…
Gold nanoparticles (NPs) have been stabilized with a variety of thiol-containing molecules in order to change their chemical and physical properties; among the possible capping systems, alkane chains with different lengths, a carboxylic acid and a thiol-containing biomolecule (tiopronin) have been selected as protecting shells for the synthesized NPs; the NPs solubility in water or…