Plasma power-to-X (PP2X): status and opportunities for non-thermal plasma technologies

This article discusses the ‘power-to-X’ (P2X) concept, highlighting the integral role of non-thermal plasma (NTP) in P2X for the eco-friendly production of chemicals and valuable fuels. NTP with unique thermally non-equilibrium characteristics, enables exotic reactions to occur under ambient conditions. This review summarizes the plasma-based P2X systems, including plasma discharges, reactor configurations, catalytic or non-catalytic…

Factors triggering germination in plasma-activated cotton seeds: water imbibition vs. reactive species’ formation

Plasma technology has emerged as an efficient, simple, and eco-friendly method for activating seed germination processes. Most studies on this subject have focused on the morphological and wetting effects on the surface state of seeds and attributed the improvement in germination occasionally found to the induced hydrophilicity and a higher water imbibition rate. Recently, the…

Biodegradable polyester films from renewable aleuritic acid: surface modifications induced by melt-polycondensation in air

Good water barrier properties and biocompatibility of long-chain biopolyesters like cutin and suberin have inspired the design of synthetic mimetic materials. Most of these biopolymers are made from esterified mid-chain functionalized.-long chain hydroxyacids. Aleuritic (9,10,16-trihydroxypalmitic) acid is such a polyhydroxylated fatty acid and is also the major constituent of natural lac resin, a relatively abundant…

Nanoindentation and scratch resistance of multilayered TiO2-SiO2 coatings with different nanocolumnar structures deposited by PV-OAD

This paper presents a study of the mechanical properties and an evaluation of damage mechanisms of nanocolumnar TiO2-SiO2 multilayer coatings prepared by physical vapour oblique angle deposition at different configurations (slanted, zigzag or chiral) and two zenithal evaporation angles (70 degrees or 85 degrees). The characterization at micro-and nanometric length scales of the mechanical properties…

Atomistic model of ultra-smooth amorphous thin film growth by low-energy ion-assisted physical vapour deposition

The growth of ultra-smooth amorphous thin films induced by low-energy (below 1 keV) ion-assistance processes is studied. The relative contribution of ion-induced smoothening effects is analysed by means of a Monte Carlo model and experimental data. In general, highly rough granular or ultra-smooth (with roughness below one monolayer) films are produced depending on the competition…

Phase composition and tribomechanical properties of Ti-B-C nanocomposite coatings prepared by magnetron sputtering

Protective nanocomposite coatings based on hard ceramic phases (TiC, TiB2) combined with amorphous carbon (a-C) are of interest because of their adequate balance between mechanical and tribological performances. In this work, Ti–B–C nanocomposite coatings were prepared by co-sputtering of graphite and TiB2 targets. Varying the discharge power ratio applied to the graphite and TiB2 targets…

Theoretical and experimental characterization of TiO2 thin films deposited at oblique angles

The microstructural features of amorphous TiO2 thin films grown by the electron beam physical vapour deposition technique at oblique angles have been experimentally and theoretically studied. The microstructural features of the deposited films were characterized by considering both the column tilt angle and the increase in the column thickness with height. A Monte Carlo model…