Grinding of clays modifies their surfaces and can significantly affect their leaching behaviour. The acid reaction of vermiculite from Santa Olalla (Huelva, Spain) with HCl at various concentrations was affected by grinding and acid concentration. The acid leaching of ground vermiculite for 3 min with 1 M HCl solution at 80 °C for 24 h…
In this work some carbon-based coatings were studied by atomic force microscopy (AFM) and lateral force microscopy (LFM) techniques in order to evaluate their microstructure and friction properties at the micro and nanoscale. With this aim, four samples were prepared by magnetron sputtering: an amorphous carbon film (a–C), two nanocomposites TiC/a–C with different phase ratio…
A series of Ce1−xEuxO2−x/2 mixed oxides was synthesized by coprecipitation. The solids were characterized by means of XRF, SBET, XRD, UV−vis, and Raman techniques, and their catalytic activities toward CO oxidation were tested. A solid solution, with CeO2 F-type structure, is formed for europium contents (measured as Eu2O3 by XRF) ≤20% wt. For higher contents,…
This work reports a procedure to modify the surface nanostructure of TiO2 anatase thin films through ion beam irradiation with energies in the keV range. Irradiation with N+ ions leads to the formation of a layer with voids at a depth similar to the ion-projected range. By setting the ion-projected range a few tens of…
The properties of TiCxN1−x/(Ni or Co) cermets sintered by a pressureless method from powder mixtures, and obtained for the first time by a mechanically induced self-sustaining reaction process (MSR), were studied. The hardness, toughness, friction and wear coefficients, and oxidation resistance were determined. It was shown that cermets obtained from powdered materials synthesized in one…
Characterization of four amalgam surfaces, with different alteration degrees from Andalusia historical mirrors, has been carried out by grazing-incidence X-ray diffraction (GIXRD), and other spectroscopic techniques (SEM/EDX, XPS, and REELS). The combination of all these techniques allows determining the corrosion state of the amalgams. The results show that the amalgams are composed in all cases…
Ta2O5 thin films with different nanostructure and surface roughness have been prepared by electron evaporation at different angles between the evaporation source and the substrates. Large variation of refraction indexes (n) from 1.40 to 1.80 were obtained by changing the geometry of evaporation and/or by annealing the evaporated films at increasing temperatures up to 1000…
Amorphous hydrogenated silicon carbide (a-SiC:H) films are produced by remote microwave hydrogen plasma (RHP)CVD using triethylsilane (TrES) as the single-source precursor. The reactivity of particular bonds of the precursor in the activation step is examined using tetraethylsilane as a model compound for the RHP-CVD experiments. The susceptibility of a TrES precursor towards film formation is…
This paper is devoted to the development of Ti(C,N)-based nanocomposite protective coatings consisting of nanocrystals of a hard phase (TiN or TiCxNy) embedded in an amorphous carbon-based matrix (a-C or a-CNx). The objective here is the achievement of a good compromise between the mechanical and tribological properties by the appropriate control of the hard/soft phase…
