In this paper, a series of f(alpha) kinetic equations able to describe the random scission degradation of polymers is formulated in such a way that the reaction rate of the thermal degradation of polymers that go through a random scission mechanism can be directly related to the reacted fraction. The proposed equations are validated by…
The micro and nanostructure of Cu-Al, Cu-V and Cu-Ti alloys produced by reactive milling were analyzed using X-ray diffraction (XRD) and transmission electron microscopy (TEM). Samples with different milling times (t = 0, 10, 20 and 30 h) were considered. The grain size, dislocation density and residual microstrain were evaluated form the XRD data using…
High-purity, nanometer-sized titanium carbonitride powders, TiCxN1-x, were obtained with a mechanically induced self-sustaining reaction (MSR) in a high-energy planetary ball mill from a mixture of titanium and different carbon precursors under a nitrogen atmosphere. A promising method for developing dense TiCxN1-x materials is the coupling of MSR with the spark plasma sintering (SPS) technique. The…
The synthesis of solid solutions in the HfB2-ZrB2 system was conducted by mechanically induced self-sustaining reaction (MSR) processes under an inert atmosphere from elemental mixtures of Hf, Zr, and B. The stoichiometry of the Hf1-xZrxB2 solid solution phase was controlled by adjusting the Hf/Zr/B atomic ratio in the starting mixture. Composite materials with SiC were…
Combined kinetic analysis has been applied for the first time to the thermal degradation of polymeric materials. The combined kinetic analysis allows the determination of the kinetic parameters from the simultaneous analysis of a set of experimental curves recorded under any thermal schedule. The method does not make any assumptions about the kinetic model or…
A new method for preparing high surface area α-alumina from urban waste is proposed. The method consists of the precipitation of a precursor that contains bohemite mixed with a linear polymer and subsequently the thermal decomposition of the precursor by heating in nitrogen and air to 1200 °C. The resulting α-alumina consists of nanocrystals of…
The machinability of materials is a dynamic field with enormous implications in different industrial sectors because manufacturers are constantly looking for improvements that can increase the overall productivity. Manufacturers of cutting tool inserts need to develop products that can perform at higher speeds and last longer under increasingly rigorous operating conditions. It has been revealed…
The recent paper by Jankovic et al. [B. Janković, B. Adnađevic, J. Jovanović; Thermochimica Acta 452 (2007) 106] and other similar papers have raised a problem which needs to be resolved. These authors use the method of Kennedy and Clark [J.A. Kennedy, S.M. Clark, Thermochimica Acta 307 (1997) 27] which is conceptually erroneous; this is…
The dynamic heating rate method developed by TA Instruments (Hi-ResTM) is a kind of sample controlled thermal analysis in which a linear relationship between the logarithm of the heating rate and the rate of mass change is imposed. It is shown in this paper that the reacted fraction at the maximum reaction rate strongly depends…
