In this study, the feasibility of preparing novel Ca-doped high entropy La(Co,Cu,Fe,Mn,Ni)O3-delta perovskites by mechanochemical synthesis was explored. It was found that monophasic compounds can be obtained after 150 h of milling, characterized by the nano size of their crystals and a significant concentration of oxygen vacancies, likely due to the incorporation of bivalent cations…
Two series of open metal site MOFs, HKUST-1 and MIL-100(Fe), have been successfully prepared using different methods of synthesis. Their features depend on the synthetic route as well as their role play in different environmental applications. The stability and performance of these BTC-based MOFs have been tested bearing in mind Congo Red (CR) removal, humidity…
A model is presented giving the mean dimensions of acicular octadecahedral microcrystallites of a rutile titanium dioxide powder. Reduction at 823 K, in conjunction with ESR, electrical conductivity and controlled re-oxidation has enabled the model to be applied to reduced microcrystallites. At 300 K they contain <0.1% of paramagnetic [Ti3+↑ VO: ↑Ti3+] reduced edge sites and >99.9% of reduced spin-paired [Ti3+↑↓ Ti3+ VO:] sites. These sites are situated…
Different mixed-linker MOFs based on HKUST-1 have been successfully synthesized using BtTC (1,2,4,5-benzenetetracarboxylate) and BDC (1,4-benzenedicarboxylate) as modulator ligands. These MOFs maintain the HKUST-1 structure up to 25% and 50% of trimesic acid replacing with BtTC and BDC ligands, respectively. A low percentage of modulator ligand provokes an increasing of the MOF surface area keeping…
LaAl1-xNixO3 (with x = 0.05 and 0.2) perovskite oxides were successfully synthesized and its behavior under reduction atmosphere was studied. HRTEM and STEM studies, coupled to HAADF and EDX detection, allowed to evidence the Ni exsolution process to the surface of the solid and to build nano-catalytic centers. The size of these centers is independent…
Niobium carbonitride [Nb(C,N)] nanoparticles were synthesized by a combustive mechanochemical reaction in the Mg/Nb2O5/C3H6N6 system. High-energy ball milling was used to promote a mechanically induced self-sustaining reaction (MSR). Combustion occurred after a very short milling period of 5 min. X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), energy-dispersive X-ray spectroscopy (EDS) and electron energy loss spectroscopy…
Chromium incorporation into TiO 2 up to 3 GPa at 1300 °C and 900 °C has been studied by XRD as well as TEM. A CaCl 2 type TiO 2 polymorph has been observed in the quenched samples from high pressure. Two different mechanisms of solubility occur in the recovered samples. Chromium replaces titanium on…
Monophase nanocrystalline powders belonging to the La1−xSrxMnO3±δ system (0≤x≤1) with a perovskite structure have been obtained by mechanochemistry synthesis using a planetary ball milling equipment from La2O3, SrO, and Mn2O3 mixtures. The solid state reaction was complete after one hour of milling treatment. For all the compositional range, the diffraction domain was very small and…
Ce0.9M0.1O2-δ mixed oxides (M=La, Eu and Gd) were synthesized by coprecipitation. Independent of the dopant cation, the obtained solids maintain the F-type crystalline structure, characteristic of CeO2 (fluorite structure) without phase segregation. The ceria lattice expands depending on the ionic radii of the dopant cation, as indicated by X-ray diffraction studies. This effect also agrees…
Ce0.9M0.1O2-δ mixed oxides (M=La, Eu and Gd) were synthesized by coprecipitation. Independent of the dopant cation, the obtained solids maintain the F-type crystalline structure, characteristic of CeO2 (fluorite structure) without phase segregation. The ceria lattice expands depending on the ionic radii of the dopant cation, as indicated by X-ray diffraction studies. This effect also agrees…