Effect of Mo and W interlayers on microstructure and mechanical properties of Si3N4-nickel-base superalloy joints

Si3N4/nickel-base superalloy (Inconel-625) and Si3N4/Si3N4 joints with refractory metal (W and Mo) interlayers were vacuum brazed using a Ti-active braze Cu-ABA (92.75Cu-3Si-2Al-2.25Ti) at 1317 K for 30 min with the following interlayered arrangements: Si3N4/Mo/W/Inconel and Si3N4/Mo/W/Si3N4. The joints exhibited Ti segregation at the Si3N4/Cu-ABA interface, elemental interdiffusion across the joint interfaces, and sound metallurgical bonding.…

Strength and thermal shock resistance of fiber-bonded Si-Al-C-O and Si-Ti-C-O ceramics

Silicon carbide-based fiber-bonded ceramics, obtained from hot pressing of woven silicon carbide fibers, are a cost-effective alternative to ceramic-matrix composites due to their ease of fabrication, involving few processing steps, and competitive thermomechanical properties. In this work, we studied the high-temperature strength and thermal shock resistance of Si-Al-C-O and Si-Ti-C-O fiber-bonded SiC ceramics obtained from…

In Situ Synthesis of a ZrB2-Based Composite Powder Using a Mechanochemical Reaction for the Zircon/Magnesium/Boron Oxide/Graphite System

A ZrSiO4/B2O3/Mg/C system was used to synthesize a ZrB2-based composite through a high-energy ball milling process. As a result of the milling process, a mechanically induced self-sustaining reaction (MSR) was achieved in this system. A composite powder of ZrB2-SiC-ZrC was prepared in situ by a magnesiothermic reduction with an ignition time of approximately 6min. The…